865 Highway 169 N.
Plymouth, Mn. 55441

Elite Figure Skate Holder

Jaw Set Only

• FITS ALL SIZES OF FIGURE BLADES, CHILD THRU ADULT.
• LOCATES AND CLAMPS ACROSS THE BLADE STANCHIONS SO THAT EVEN TAPERED SIDE HONED BLADES CAN BE HELD ACCURATELY AND CONSISTENTLY.
• BOTTOM JAW IS A STEEL INVESTMENT CASTING FOR EXTREME DURABILITY. TOP JAW IS A BRASS INVESTMENT CASTING TO HOLD HIGH-END SKATES WITHOUT SCRATCHING THE CHROME PLATING.
• CARRIAGE IS CAST ALUMINUM FOR LIGHTWEIGHT, 9 ¾” WIDE FOR EXCELLENT STABILITY.
• REPLACEMENT FELT WEAR PADS FOR SMOOTH GLIDE.
• INFINITELY ADJUSTABLE WITH INDEPENDENT HEIGHT, LEVEL AND ANGLE OF APPROACH CONTROLS.

ONE FULL TURN OF TILT CONTROL DIAL WITH CHANGE THE DISPARITY OF THE EDGES BY APPROXIMATELY .0014”.

IF FIGURE SKATE SHARPENING IS YOUR SPECIALTY THIS IS THE HOLDER.

IF YOU ARE A VOLUME SHARPENING SHOP YOU SHOULD HAVE TWO SKATE HOLDERS. ONE SET UP FOR HOCKEY AND ONE FOR FIGURE. IN THIS WAY YOU AVOID SET UP TIMES AND POSSIBLE SET UP ERRORS GOING BACK AND FORTH BETWEEN (THIN) HOCKEY BLADES AND (THICK) FIGURE BLADES. AVAILABLE IN 4 5 / 8” HEIGHT FOR ALL WISSOTA MACHINES OR 4 1 / 2” HEIGHT FOR OTHER POPULAR SKATE SHARPENING MACHINES.

AVAILABLE AS A “COMPLETE HOLDER” OR “JAW SET” ONLY. THE JAW SET WILL REPLACE THE STANDARD JAWS IN ANY WISSOTA “TANGENT FINDER” SKATE HOLDER.

“ELITE” FIGURE SKATE HOLDER COMPLETE, $240.00
NOTE: STATE HEIGHT WHEN ORDERING, 4 5 /8” OR 4 1 / 2”.“ELITE” FIGURE SKATE HOLDER WILL NOT HOLD HOCKEY SKATES.

“ELITE” FIGURE SKATE JAWS SET ONLY, $142.00
NOTE: YOU MUST ALREADY HAVE A STANDARD WISSOTA “TANGENT FINDER” HOLDER.“ELITE” JAWS WILL NOT HOLD HOCKEY SKATES.

PLEASE CALL THE FACTORY IF YOU HAVE ANY QUESTIONS ON THE “ELITE” FIGURE SKATE HOLDER

ELITE FIGURE SKATE HOLDER WEB SITE ADDITON